Two minutes to understand the installation of plate heat exchanger

1. Installation foundation

The main purpose of the installation foundation is to facilitate the installation of the heat exchanger and the connection of various pipes, so as to facilitate the repair and maintenance of the heat exchanger in the future. Generally, when leaving the factory, three anchors and dimension drawings will be provided. Users can make embedded parts in the foundation according to the dimension drawings and equipment (components pre-installed in the hidden project).

During installation, tighten the anchor nut bolt in order to shake during startup, thus affecting the performance of the heat exchanger. It is also important to note that external forces cannot be applied to the equipment during installation to avoid deformation and affect operation.

Contact Aikstransfer to buy accessories. www.aiksintl.com.   email:aiks@aiksintl.com

2. Piping connection

During connection, attention should be paid to the connection positions of the hot side and outlet pipes and the cold side inlet. When the equipment is designed and selected, it should be marked on the design parameters (the interface direction of the flow is 1 can be marked with D1 hot inlet, D2 hot outlet, D3 cold inlet, etc.). The installation personnel should make sure that each pipe function has been checked before piping connection. When connecting, check whether there are sundries inside the pipe to avoid equipment blockage or affecting heat exchange efficiency.